Documentation only. This model is not listed in the online store. Contact FlyingRC for availability.
Overview
A fixed-wing F405 autopilot board for ArduPilot/INAV-style airplane builds. It sits between receiver/sensors and aircraft servos/ESC, handling stabilization, navigation, telemetry, and flight-mode control.
- STM32F405 fixed-wing autopilot controller
- ArduPilot/INAV-style airplane control workflow
- Wiring layout reference for receiver, GPS, telemetry, and PWM outputs
Hardware revision
Check the sensor markings and component layout on your board against the manual and diagrams below.
Setup notes
- Start with the fixed-wing firmware recommended in the manual, then verify receiver, GPS, telemetry, PWM outputs, and power before motor testing.
- Use the wiring/layout image as the authoritative connector reference.
- Check firmware documentation before mapping UART/USART to ArduPilot SERIAL numbers.
- ArduPilot SERIAL numbers do not always match the printed UART/USART names.
Wiring & pinouts
Compare the supplied reference with the markings and revision of your own unit before use.
Board layout & identification
Compare the supplied reference with the markings and revision of your own unit before use.
Dimensions & mounting
Check the published dimensions and connector clearance against your installation.
Original specification reference
View original reference sheets (1)
Original specification sheets are retained as a reference. Use the revision notices on this page when comparing sensor or configuration variants.
