Skip to content

10A 2–8S BEC

Pinouts, setup notes and firmware references. Match the exact hardware revision before connecting or flashing.

BEC / regulatorFixed-wing2-8S LiPoSelectable BEC outputHigh-current build

Wiring & pinouts Manuals & references Product page

Overview

A compact high-current BEC for aircraft and other projects that need a selectable regulated supply.

6-36 V input; 2-8S LiPo
5 V default output; 6 V / 7 V selectable by jumper
10 A continuous with heatsink or airflow; 12 A peak at 5 V
33.9 x 18.5 x 5.5 mm; 10.3 mm with heatsink

Hardware revision

Check the sensor markings and component layout on your board against the manual and diagrams below.

Setup notes

Connect the battery to VIN and the load to VOUT.
Attach the heatsink to the reverse side before sustained high-current use.

Input voltage must remain at least 0.8 V above the selected output voltage.

Wiring & pinouts

Compare the supplied reference with the markings and revision of your own unit before use.

Wiring and jumper selection — Wiring and jumper selection · Open full-size image

Dimensions & mounting

Check the published dimensions and connector clearance against your installation.

Dimension drawing — Dimension drawing · Open full-size image

Original specification reference

View original reference sheets (1)

Original specification sheets are retained as a reference. Use the revision notices on this page when comparing sensor or configuration variants.

Parameter table — Parameter table · Open full-size image

Manuals & references

Product manualOpen / download

Back to product