Overview
A higher-voltage step-down BEC for converting 2-12S battery voltage into a regulated lower output for onboard electronics.
- 10 A step-down BEC module
- 6-60 V / 2-12S LiPo input range
- Designed for higher-current accessory power
Hardware revision
Check the sensor markings and component layout on your board against the manual and diagrams below.
Setup notes
- Confirm output voltage and polarity before connecting flight electronics.
- Keep high-voltage battery wiring physically separated from signal wiring where possible.
- Input: 6-60 V / 2-12S LiPo.
- Input voltage must be at least about 0.8 V higher than selected output voltage.
- Use connection diagrams for battery and capacitor wiring.
- High-voltage batteries can destroy low-voltage electronics if wired incorrectly.
Wiring & pinouts
Real connection photos show battery-input and capacitor placement. Check VIN/VOUT and polarity; disconnect power before soldering.
Board layout & identification
Compare the supplied reference with the markings and revision of your own unit before use.
Dimensions & mounting
Check the published dimensions and connector clearance against your installation.
Original specification reference
View original reference sheets (1)
Original specification sheets are retained as a reference. Use the revision notices on this page when comparing sensor or configuration variants.
Manuals & references
Product manualOpen / download